JANUS? 2020 Hand-Held Computer (4MB) - Intermec

Intercharacter Delay
12
NF BC Configuration Command Reference
Purpose: Defines the amount of time the reader waits before sending each character to
the host. It modifies outgoing data only by slowing the speed of transmission.
A character delay can be useful when the reader is communicating with a
controller through a modem using full-duplex operation.
Default: 0 sec
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see “Communications Protocol,
Configure” earlier in this chapter.
Syntax: IDdata
Acceptable values for data are:
0 0 ms
1 1 ms
2 2 ms
3 5 ms
4 10 ms
5 20 ms
6 50 ms
7 100 ms
Scan: One of these bar codes:
Intercharacter Delay, 0 ms Intercharacter Delay, 1 ms
*$+ID0* *$+ID1*
*$+ID0* *$+ID1*
Intercharacter Delay, 2 ms Intercharacter Delay, 5 ms
*$+ID2* *$+ID3*
*$+ID2* *$+ID3*
Intercharacter Delay, 10 ms Intercharacter Delay, 20 ms
*$+ID4* *$+ID5*
*$+ID4* *$+ID5*
Intercharacter Delay, 50 ms Intercharacter Delay, 100 ms
*$+ID6* *$+ID7*
*$+ID6* *$+ID7*
12-57