JANUS? 2020 Hand-Held Computer (4MB) - Intermec

JANUS 2020 Hand-Held Computer User’s Manual (4MB) NF BC
Command Processing (continued)
Or: To disable or enable specific reader commands, perform these steps:
1. Scan this bar code:
12-30
Enter Accumulate Mode / Command Processing
*+/$+DC*
*+/$+DC*
2. Scan the bar code to disable or enable one reader command.
Note: If there are two bar codes for a reader command, you must scan them in
order, left to right.
Backspace (continued)
*-* *+*
*-* *+*
Backlight Change Configuration
*%.* *$+*
*%.* *$+*
Clear (continued)
*-* *-*
*-* *-*
Enter Accumulate Mode (continued)
*+* */*
*+* */*
Exit Accumulate Mode (continued)
*-* */*
*-* */*
IRL File, Clear IRL File, Receive
*.$* *.%*
*.$* *.%*