JANUS? 2020 Hand-Held Computer (4MB) - Intermec

JANUS 2020 Hand-Held Computer User’s Manual (4MB) NF BC
Entering Variable Data in a Configuration Command
12-6
You can enter variable data for many of the configuration commands. For
example, you can set the End of File (EOF) character to any ASCII character.
You need to follow these general instructions to enter variable data.
To enter variable data in a configuration command
1. Scan a bar code label with this syntax:
+/$+command
where:
+/ is the syntax for the Enter Accumulate Mode command.
$+ is the syntax for the Change Configuration command.
command is the syntax for the command you want to change.
For example, the command syntax for EOF is FAdata. To change the EOF
configuration, scan this bar code:
Enter Accumulate Mode / Change Configuration / Set EOF
*+/$+FA*
*+/$+FA*
2. Scan a bar code label from the “Full ASCII Bar Code Chart” in Appendix C.
To set EOF to SOH (Start of Heading), scan this label:
SOH
*$A*
**
3. Scan the Exit Accumulate Mode bar code label to update the reader’s
configuration:
Exit Accumulate Mode
*-/*
*-/*