JANUS? 2020 Hand-Held Computer (4MB) - Intermec

JANUS 2020 Hand-Held Computer User’s Manual (4MB)NF NF BC BC
Using MakeDisk (continued)
Message Explanation/Solution
Makedisk was unable to complete the
drive image. Try again.
Please specify a source path where your
drive image can get its files from.
The root directory can only contain [n]
files; your source files exceed this count.
Place some of your root files in a
subdirectory as an alternative.
The system has too many files open;
unable to create a drive image. Increase
the 'FILES=' setting in your CONFIG.SYS
file or terminate other applications that
may be running.
Your source files would create a [n] byte
image file which is [n] bytes in excess of
drive [C: or D:] capacity.
10-26
You may receive this message for several types of general faults
such as:
• One or more of the files in the source directory could not be
accessed. This could indicate a corrupt file or a bad disk.
• A network error occurred when DOS attempted to retrieve
a remote file.
• DOS was unable to read the source directory for any
number of reasons.
Enter a valid subdirectory name where your source files reside
that will be used to create the drive image. (This is the
/s=[path] argument).
Your source directory (first level) contains more than the
maximum number of files and/or subdirectories permitted for
the target drive’s root directory. One approach to solve this is to
place some of the first-level files in a subdirectory below your
source directory.
MakeDisk needs to open several files during the image file
creation process, but is unable to do so. You may need to
terminate other applications or close some files in order to
complete the MakeDisk process.
The total size of the files and subdirectories in your source
directory, including the overhead space required to emulate a
DOS compatible drive, exceeds the storage capacity of the
JANUS drive you have targeted.