JANUS? 2020 Hand-Held Computer (4MB) - Intermec

FTA Command Descriptions and Syntax
NF BC Networking the Reader
6
Learning the Syntax of FTA Commands
This section describes each FTA command and its syntax. You can abbreviate
the command names as shown in the Syntax column of the next table. Also,
you do not have to capitalize the commands; the commands are not case
sensitive.
Command Description Syntax
CHECKHOST Checks if the host computer rebooted
the reader and is ready to proceed
with the reader as the server and the
host computer as the client. You can
type this command only from the
reader’s DOS command line.
CLOSE Terminates the connection with the
host computer. You can abbreviate
this command as CL.
EXIT Terminates the FTA program and
returns you to the DOS prompt on
the reader.
GET Copies a file from the host computer
to the reader.
HELP Displays a description of the FTA
commands, syntax, and parameters.
LUPGRADE Upgrades the reader’s drive C from
the reader. Stands for “local
upgrade.”
ch [port]
where:
port is the COM port for the connection. If
you do not specify a port, the
application uses the first port with an
active protocol handler.
c
e
g hfile [rfile]
where:
hfile is the path and filename of the file to be
transferred from the host computer to
the reader.
rfile is the destination path and filename on
the reader. If you do not specify a rfile
name, the hfile name is used.
h
l file c
where:
file is the path and filename of the image
file on the JANUS reader, and C is the
drive to be updated.
6-51