JANUS? 2020 Hand-Held Computer (4MB) - Intermec

NF BC Networking the Reader
Installing Interlnk on the Host Computer
You need two files to run Interlnk:
INTERLNK.EXE The device driver that you load into the client’s memory.
INTERSVR.EXE The program that you run on the server.
6
You must install those files on the host computer before you can run Interlnk
or Intersvr on the host. You can install the files from either the MS-DOS
companion disk 2 or the reader’s drive D.
To install Interlnk on the host computer from companion disk 2
1. On the host computer, make sure that the current working directory is the
directory where you want to install the Interlnk files.
2. Insert companion disk 2 into a disk drive on the host computer.
3. Copy INTERLNK.EXE and INTERSVR.EXE from companion disk 2 to the
host computer.
To install Interlnk on the host computer from the reader’s drive D
1. Connect the reader to the host computer using a 7-wire, null-modem serial
cable and either the communications dock or optical link adapter.
2. Make sure that the MODE command is available on the host computer.
3. On the host computer, make sure that the current working directory is the
directory where you want to install the Interlnk files.
4. At the reader’s DOS prompt, type this command to copy the Interlnk files
from the reader’s drive D to the host computer:
intersvr /rcopy
Or scan this bar code:
*INTERSVR /ORCOPY*
*INTERSVR /RCOPY*
Follow any instructions displayed on the reader. If the host computer locks
up after you copy the files, reboot the host.
6-29