JANUS? 2020 Hand-Held Computer (4MB) - Intermec

NF BC Networking the Reader
6
Loading and Unloading a Protocol Handler With an Application
You can load a protocol handler for a designated port when you start the IRL
Desktop or Communications Manager. When you exit the program, the
protocol handler is automatically unloaded.
To load a protocol handler by starting IRL Desktop or Communications Manager
• Type this command at the DOS prompt:
application [-portph]
where:
application is the application you are executing:
irl IRL Desktop
cmgr Communications Manager
port is the number of the reader’s COM port.
ph is the code for the protocol handler:
i Intermec protocol handler
p PC standard protocol handler
r RF protocol handler
For example, to load the Intermec protocol handler on COM1 and execute
the IRL Desktop, type this command at the DOS prompt:
irl -1i
Or scan this bar code:
*IRL-1I*
*IRL -1I*
6-19