JANUS? 2020 Hand-Held Computer (4MB) - Intermec

JANUS 2020 Hand-Held Computer User’s Manual (4MB) NF BC
4-18
To delete all the files on the flash card in drive G, type this command at the
DOS prompt:
del g:\*.*
If you need more information about DOS commands, refer to any book that
describes DOS commands.
You can also use MCFORMAT to format an existing partition on the flash PC
card, or display information about the card’s partitions. To do so, start
MCFORMAT and choose options 2 or 4, respectively.
Preparing to Use I/O Cards
You can use I/O expansion cards in the PC card drive. To use an I/O card in
the drive, you need to add the I/O card drivers and utilities to
AUTOEXEC.BAT and CONFIG.SYS.
Note: Before you use an I/O card in your JANUS device, read the documentation
shipped with the PC card for any instructions on using your card. Some cards may
need to be configured before they can be used in the PC card drive.
Configuring the JANUS device to Use an I/O Card
Follow these steps to configure the JANUS device for an I/O card:
1. Edit the AUTOEXEC.BAT file, which is stored on the drive C.
2. Search for this line in the AUTOEXEC.BAT file:
d:\apm_4m.exe
If the line is remarked out, delete the REM characters. If you cannot find
this line, add it to the AUTOEXEC.BAT file.
3. Remark out this line:
d:\ipm_4m.exe
Note: Do not load both IPM_4M.EXE or APM_4M.EXE at the same time.
4. Save your changes to the AUTOEXEC.BAT file.
5. Edit the CONFIG.SYS file on the JANUS drive C.
6. Search for this line in the CONFIG.SYS file:
device=d:\cardid.exe d:\cardid.ini
If the line is remarked out, delete the REM characters. If you cannot find
this line, add it to the CONFIG.SYS file.
7. To save conventional memory, remark out any lines that load drivers for
ATA, flash, or SRAM cards.