JANUS? 2020 Hand-Held Computer (4MB) - Intermec

NF BC Learning About the Software
7. Type this command at the host computer’s DOS prompt:
makedisk /s=c:\drivec /o=newdrv.img
3
MakeDisk creates an image file, NEWDRV.IMG, in the working directory
of the host computer’s drive C.
8. Restart Interlnk. Make the JANUS device the client, and the host computer
the server. The new image file, NEWDRV.IMG, appears on the H drive root
directory.
9. At the DOS prompt on the JANUS device, type this command to load the
image file to drive C.
putdisk /i=h:\newdrv.img
Example 3
In this example, the resulting image file will update drive D. Since the image
file will be larger than 256K, you must create the image file on the host
computer if the JANUS RAM drive is configured at 256K (factory default). This
example assumes that the host computer and your JANUS device can share a
PC card.
1. Connect the JANUS device to a host computer using an appropriate serial
connection.
2 Create a source directory on the host computer by typing this command at
the host computer’s DOS prompt:
mkdir c:\drived
3. Fill the source directory with all the files you want to include in the new
image file:
a. Copy the files from the current drive D to the source directory. Because
the host computer and your JANUS device can share a PC card, you can
insert the card into the JANUS PC card drive and copy all files from
drive D to drive G. Then insert the card into the host computer’s PC
card drive and copy all the files to the source directory.
b. Add any other files and/or subdirectories to the source directory that
you want on drive D. These files may include read-only data files and
applications for your JANUS device.
4. Insert the JANUS Boot Utilities companion disk into a drive on the host PC.
5. Copy the self-expanding executable C_MAKE.EXE to drive C on the host
PC by typing:
copy a:\c_make.exe c:\
6 Run C_MAKE.EXE and delete all of the extracted files except for
MAKEDISK.EXE.
3-31