U UNIVAC 1218 - Bitsavers

CHANGE 1
4) ILLEGAL OPERATOR.
The operation code is either incorrect or not placed in the proper
columns of the CTT card. When the condition is corrected, start the
computer.
5) ILLEGAL JOB NUMBER.
A job number is greater than two digits, job numbers are not properly
separated by punctuation, or the first job number does not begin in
column 34 of the CTT card.
6) ILLEGAL TAPE FORMAT.
The components of the From and/or the To tape format(s) are improperly
represented by the letter codes or the letter codes are placed incorrectly
in the columns of the CTT card.
7) INCORRECT CTT CARD.
This typeout occurs after ILLEGAL JOB NUMBER, ILLEGAL OPERATOR, and
ILLEGAL TAPE FORMAT. It also occurs when the job number field
of a CTT card is not terminated by a period or when any information on
a CTT card is placed in an incorrect column. When the condition is
corrected, initialize the card reader and start the computer.
8) BAD INPUT TAPE.
NO RECOVERY.
This typeout indicates that the input tape is in error, and a new
input tape is required. If any manual manipulation of tape units is
necessary, the CART program must be reinitiated. Otherwise, restart
the computer.
9) MTU ERROR.
IMPROPER CONDITION.
Correct an improper conOltlOn on the tape transports that are designated
in the From and To tape fields on the CTT card. If the position of
any tapes being used is changed manually, the CART program must be
reinitiated. Otherwise, restart the computer.
10) MID ERROR.
INPUT TIMING ERROR.
NO RECOVERY.
The requirements for correction of this condition are the same as
specified for BAD INPUT TAPE.
11 ) MTU ERROR.
OUTPUT TIMING ERROR.
NO RECOVERY.
This typeout indicates a problem within CART or incorrect hardware
operation. The input tape is not in error.
IV -F -14