U UNIVAC 1218 - Bitsavers

11) Start the computer. The listings defined by the input command operations
are produced on the selected output device and the computer stops after
the typeout DONE occurs.
5. TYPEOUTS
1) CALL ERR XXXXXX.
Program XXXXXX was called but is not found in the directory or is not in
the proper order. It must follow the calling program on the library
because the tape is never rewound while calling programs during an
assembly run. Correction must be made before processing is restarted.
2) DIRECTORY.
This typeout, followed by a listing of the directory, occurs whenever a
listing of the directory is requested on paper tape.
3) DONE.
The building, updating, or listing process is complete.
4) ILL-OPERATOR XXX.
An illegal updating command has been detected. Processing continues
and the illegal command it ignored.
5) IMP COND.
An improper condition has been detected on a magnetic tape unit. Correct
the improper condition and start the computer. The magnetic tape function
will be attempted again.
6) LIBNO xxx.
Library xxx is the one being updated or listed.
7) NO HEADER.
No legal header has been read. Correct the tape or card deck, place the
corrected tape or card deck in the reader, and start over.
8) NO LIBNO.
The library to be updated or listed does not contain an identifying
library number o Correct the tape or card deck, place the corrected tape
or card deck in the reader, and start overo
9) READ XXXXXX NEXT.
The wrong source program tape or deck was mounted in the reader. Mount
the correct program and start the computer.
IV-D-9