K9agm2 - TigerDirect.com

More documents

Recommendations

Info

Connectors Hardware Setup Floppy Disk Drive Connector: FDD1 This standard FDD connector supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. FDD1 ATA133 Hard Disk Connectors: IDE1 The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 66/100/133 controller that provides PIO mode 0~4, Bus Master, and Ultra DMA 66/ 100/133 function. You can connect hard disk drives, CD-ROM and other IDE devices. The Ultra ATA133 interface boosts data transfer rates between the computer and the hard drive up to 133 megabytes (MB) per second. The new interface is one-third faster than earlier record-breaking Ultra ATA/ 100 technology and is backwards compatible with the existing Ultra ATA interface. IDE1 (Primary IDE Connector) IDE1 can connect a Master and a Slave drive. You must configure the second hard drive to Slave mode by setting the jumper accordingly. IDE1 Important If you install two hard disks on IDE cable, you must configure the second drive to Slave mode by setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions. 2-11
2-12 MS-7327 Mainboard Serial ATA II Connectors: SATA1~SATA4 SATA1~SATA4 are high-speed SATAII interface ports. Each supports data rates of 300 MB/s and is fully compliant with Serial ATA specifications. Each Serial ATA connector can connect to 1 hard disk device. SATA4 7 SATA2 SATA1 1 Serial ATA cable SATA3 Connect to SATA connector Important Pin Definition PIN SIGNAL PIN SIGNAL 1 GND 2 TXP 3 TXN 4 GND 5 RXN 6 RXP 7 GND Take out the dust cover and connect to the hard disk devices Please do not fold the Serial ATA cable into 90-degree angle. Otherwise, data loss may occur during transmission.
Page 1 and 2: i K9AGM2 MS-7327 (v1.X) Mainboard G
Page 3 and 4: Safety Instructions 1. Always read
Page 5: WEEE (Waste Electrical and Electron
Page 8 and 9: CONTENTS Copyright Notice .........
Page 10 and 11: Chapter 1 Getting Started Getting S
Page 12 and 13: Floppy Getting Started - 1 floppy p
Page 14 and 15: Packing Checklist MSI motherboard P
Page 16 and 17: Chapter 2 Hardware Setup Hardware S
Page 18 and 19: CPU (Central Processing Unit) Hardw
Page 20 and 21: Hardware Setup Installing AMD Socke
Page 22 and 23: Hardware Setup Installing DDRII Mod
Page 24 and 25: Back Panel Mouse Parallel Port Keyb
Page 28 and 29: Hardware Setup Fan Power Connectors
Page 30 and 31: Hardware Setup Front USB Connectors
Page 32 and 33: Hardware Setup IEEE 1394 Connector:
Page 34 and 35: Jumpers Hardware Setup Clear CMOS J
Page 36 and 37: Hardware Setup PCI (Peripheral Comp
Page 38 and 39: 3-2 MS-7327 Mainboard Entering Setu
Page 40 and 41: 3-4 MS-7327 Mainboard The Main Menu
Page 42 and 43: 3-6 MS-7327 Mainboard Standard CMOS
Page 44 and 45: 3-8 MS-7327 Mainboard System Inform
Page 46 and 47: 3-10 MS-7327 Mainboard MPS Table Ve
Page 48 and 49: 3-12 MS-7327 Mainboard Surround Vie
Page 50 and 51: 3-14 MS-7327 Mainboard OnChip SATA
Page 52 and 53: 3-16 MS-7327 Mainboard Re-Call VGA
Page 54 and 55: 3-18 MS-7327 Mainboard PNP/PCI Conf
Page 56 and 57: 3-20 MS-7327 Mainboard H/W Monitor
Page 58 and 59: 3-22 MS-7327 Mainboard Load Optimiz
Page 60 and 61: A-2 MS-7327 Mainboard Installing th
Page 62 and 63: A-4 MS-7327 Mainboard Software Conf
Page 64 and 65: A-6 MS-7327 Mainboard Equalizer Sel
Page 66 and 67: A-8 MS-7327 Mainboard Mixer In the
Page 68 and 69: A-10 MS-7327 Mainboard 3. Playback
Page 70 and 71: Audio I/O A-12 MS-7327 Mainboard In
Page 72 and 73: A-14 MS-7327 Mainboard S/PDIF Short
Page 74 and 75: A-16 MS-7327 Mainboard Microphone I
Page 76 and 77:
A-18 MS-7327 Mainboard Information
Page 78 and 79:
A-20 MS-7327 Mainboard n 4-Channel
Page 80 and 81:
A-22 MS-7327 Mainboard n 8-Channel
Page 82 and 83:
B-2 MS-7280 Mainboard RAID Configur
Page 84 and 85:
B-4 MS-7280 Mainboard Define LD (Cr
Page 86 and 87:
B-6 MS-7280 Mainboard Press ESC key
Page 88 and 89:
B-8 MS-7280 Mainboard Installing th
show all

K9agm2 - TigerDirect.com

Create successful ePaper yourself

Delete template?

Save as template?