K9agm2 - TigerDirect.com

More documents

Recommendations

Info

Hardware Setup Installing AMD Socket AM2 CPU Cooler Set When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating. If you do not have the heat sink and cooling fan, contact your dealer to purchase and install them before turning on the computer. Important Mainboard photos shown in this section are for demonstration of the cooler installation for Socket AM2 CPUs only. The appearance of your mainboard may vary depending on the model you purchase. 1. Position the cooling set onto the retention mechanism. Hook one end of the clip to hook first. 2. Then press down the other end of the clip to fasten the cooling set on the top of the retention mechanism. Locate the Fix Lever and lift up it . Fixed Lever 3. Fasten down the lever. 4. Attach the CPU Fan cable to the CPU fan connector on the mainboard. * While disconnecting the Safety Hook from the fixed bolt, it is necessary to keep an eye on your fingers, because once the Safety Hook is disconnected from the fixed bolt, the fixed lever will spring back instantly. 2-5
2-6 MS-7327 Mainboard Memory The mainboard provides four 240-pin non-ECC DDRII DIMMs and supports up to 4 GB system memory. For more information on compatible components, please visit http://www.msi.com.tw/ program/products/mainboard/mbd/pro_mbd_trp_list.php DDRII 240-pin, 1.8V 1 56x2=112 pin Dual-Channel Memory Population Rules 64x2=128 pin DIMM1 DIMM2
Page 1 and 2: i K9AGM2 MS-7327 (v1.X) Mainboard G
Page 3 and 4: Safety Instructions 1. Always read
Page 5: WEEE (Waste Electrical and Electron
Page 8 and 9: CONTENTS Copyright Notice .........
Page 10 and 11: Chapter 1 Getting Started Getting S
Page 12 and 13: Floppy Getting Started - 1 floppy p
Page 14 and 15: Packing Checklist MSI motherboard P
Page 16 and 17: Chapter 2 Hardware Setup Hardware S
Page 18 and 19: CPU (Central Processing Unit) Hardw
Page 22 and 23: Hardware Setup Installing DDRII Mod
Page 24 and 25: Back Panel Mouse Parallel Port Keyb
Page 26 and 27: Connectors Hardware Setup Floppy Di
Page 28 and 29: Hardware Setup Fan Power Connectors
Page 30 and 31: Hardware Setup Front USB Connectors
Page 32 and 33: Hardware Setup IEEE 1394 Connector:
Page 34 and 35: Jumpers Hardware Setup Clear CMOS J
Page 36 and 37: Hardware Setup PCI (Peripheral Comp
Page 38 and 39: 3-2 MS-7327 Mainboard Entering Setu
Page 40 and 41: 3-4 MS-7327 Mainboard The Main Menu
Page 42 and 43: 3-6 MS-7327 Mainboard Standard CMOS
Page 44 and 45: 3-8 MS-7327 Mainboard System Inform
Page 46 and 47: 3-10 MS-7327 Mainboard MPS Table Ve
Page 48 and 49: 3-12 MS-7327 Mainboard Surround Vie
Page 50 and 51: 3-14 MS-7327 Mainboard OnChip SATA
Page 52 and 53: 3-16 MS-7327 Mainboard Re-Call VGA
Page 54 and 55: 3-18 MS-7327 Mainboard PNP/PCI Conf
Page 56 and 57: 3-20 MS-7327 Mainboard H/W Monitor
Page 58 and 59: 3-22 MS-7327 Mainboard Load Optimiz
Page 60 and 61: A-2 MS-7327 Mainboard Installing th
Page 62 and 63: A-4 MS-7327 Mainboard Software Conf
Page 64 and 65: A-6 MS-7327 Mainboard Equalizer Sel
Page 66 and 67: A-8 MS-7327 Mainboard Mixer In the
Page 68 and 69: A-10 MS-7327 Mainboard 3. Playback
Page 70 and 71:
Audio I/O A-12 MS-7327 Mainboard In
Page 72 and 73:
A-14 MS-7327 Mainboard S/PDIF Short
Page 74 and 75:
A-16 MS-7327 Mainboard Microphone I
Page 76 and 77:
A-18 MS-7327 Mainboard Information
Page 78 and 79:
A-20 MS-7327 Mainboard n 4-Channel
Page 80 and 81:
A-22 MS-7327 Mainboard n 8-Channel
Page 82 and 83:
B-2 MS-7280 Mainboard RAID Configur
Page 84 and 85:
B-4 MS-7280 Mainboard Define LD (Cr
Page 86 and 87:
B-6 MS-7280 Mainboard Press ESC key
Page 88 and 89:
B-8 MS-7280 Mainboard Installing th
show all

K9agm2 - TigerDirect.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?