Experiments to Control Atom Number and Phase-Space Density in ...

More documents

Recommendations

Info

Figure 8.4: MOT temperature as a function of beam power at a fixed detuning of 6 MHz. Black squares (red circles) represent Tx (Ty). By decreasing the detuning, the size of the MOT is also reduced. This behaviour is shown in figure 8.5. Figure 8.5: 1/e 2 width of the MOT as a function of detuning. Red circles (black squares) represent σx (σy). 153
A typical MOT is density-limited at a density around10 11 cm −3 . Thus, a density- limited MOT will experience atom loss as the capture volume of the MOT is reduced by tuning the beams closer to resonance. This phenomenon is shown in figure 8.6. At t = 0 the final detuning is reached. Due to the density-limit, the atom number decreases very quickly in the first few ms, until the atom number is reduced to the density-limited value. Any further atom loss is then due to two-body collisions. Figure 8.6: Atom number as a function of time after MOT compression. At the reduced trap size the density-limited atom number is exceeded, leading to fast trap loss until the density-limited value is reached. To measure the MOT temperature, typical expansion times are between 50 and 1000 µs. This poses a number of technical challenges. First, a really fast camera shutter is required to be able to take those images. The Alta U47+ (Apogee) camera uses a mechanical shutter with an opening time of approximately 5 ms. This implies that the shutter is partially open for a few ms before the picture is taken. During those ms scattered light from the MOT, i.e. a fluorescence image, is recorded on the camera, that will overlap with the absorption image. Cameras with mechanical shutters are therefore not suitable for this kind of measurement. Rather than using a mechanical shutter, the Stingray camera (Allied Vision Technologies, Stingray F-033B/C) uses an electronic 154
Page 1 and 2:
Copyright by Kirsten Viering 2012
Page 3 and 4:
Experiments to Control Atom Number
Page 5 and 6:
Acknowledgments First of all, I wou
Page 7 and 8:
Experiments to Control Atom Number
Page 9 and 10:
Table of Contents Acknowledgments v
Page 11 and 12:
Chapter 7. Lithium Apparatus 92 7.1
Page 13 and 14:
List of Tables 2.1 Physical propert
Page 15 and 16:
4.1 Vacuum chamber . . . . . . . .
Page 17 and 18:
7.39 Future vertical axis optics .
Page 19 and 20:
The development of techniques to la
Page 21 and 22:
Ptorr 10 5 10 6 10 7 10 8 10 9 260
Page 23 and 24:
Property Symbol Value Reference Ato
Page 25 and 26:
2.3.2 Hyperfine Structure So far th
Page 27 and 28:
The Wigner-Eckhart theorem can be u
Page 29 and 30:
The total magnetic moment of an ato
Page 31 and 32:
interaction. The shift in the energ
Page 33 and 34:
(a) (b) scattering length a 0 Energ
Page 35 and 36:
a laser field with frequency ω. Th
Page 37 and 38:
Here ω0 is the resonance frequency
Page 39 and 40:
Optical molasses do not provide a s
Page 41 and 42:
J=1 J=0 -1 Δ σ + σ - σ - 0 +1 -
Page 43 and 44:
phase-space density is defined as
Page 45 and 46:
which maintains a constant η = U/k
Page 47 and 48:
2.12.1 Saturated Absorption Spectro
Page 49 and 50:
Figure 2.22: Saturation absorption
Page 51 and 52:
Signal 0 Signal (a) (b) Signal Freq
Page 53 and 54:
(a) (b) (c) (d) Figure 2.24: Absorp
Page 55 and 56:
y more complex energy level structu
Page 57 and 58:
ight side of the box. An irreversib
Page 59 and 60:
time (a) (b) (c) Figure 3.3: Single
Page 61 and 62:
them to move from B to A, but close
Page 63 and 64:
Figure 4.1: Vacuum chamber. Photogr
Page 65 and 66:
( ( Figure 4.3: Helicoflex seal. (a
Page 67 and 68:
88 mm 4.2.3 Auxiliary Coils 62 mm Q
Page 69 and 70:
5 2 P 3/2 5 2 S 1/2 384. 230 484 46
Page 71 and 72:
distribution of the MOT master lase
Page 73 and 74:
shifts. First a frequency shift of
Page 75 and 76:
transition. However, the laser freq
Page 77 and 78:
4.3.1.4 Upper MOT Horizontal Slave
Page 79 and 80:
provides the beam for the upper MOT
Page 81 and 82:
demon beam λ λ horizontal MOT bea
Page 83 and 84:
scholar, Florian Schreck. It is wri
Page 85 and 86:
Atoms are then optically pumped to
Page 87 and 88:
ferred into the |F = 1,mF = 0〉 or
Page 89 and 90:
5.2 Branching Ratios and Population
Page 91 and 92:
effect of the reflected beam at zer
Page 93 and 94:
y the repulsive trough beams, gaini
Page 95 and 96:
Figure 5.9: Atom number as a functi
Page 97 and 98:
Figure 5.10: Radius of the magnetic
Page 99 and 100:
on the collision rate of atoms insi
Page 101 and 102:
ferred via the single-photon coolin
Page 103 and 104:
By comparison an atomic Fock state
Page 105 and 106:
of atoms in the two hyperfine groun
Page 107 and 108:
difference in the lifetimes is dete
Page 109 and 110:
Chapter 7 Lithium Apparatus Creatin
Page 111 and 112:
angle valve rotary feedthrough ion
Page 113 and 114:
an ion gauge controller (Granville
Page 115 and 116:
viewports (MDC, 450002) are attache
Page 117 and 118:
not trapped by the MOT impinge on t
Page 119 and 120: Should contamination of the vacuum
Page 121 and 122: Figure 7.12: The assembled Zeeman s
Page 123 and 124: 7.2.2 MOT Coils A second set of coi
Page 125 and 126: BGauss 250 200 150 100 50 30 20 10
Page 127 and 128: are required to create the high mag
Page 129 and 130: The coils are then checked for shor
Page 131 and 132: + B A Figure 7.23: Feshbach coil H-
Page 133 and 134: ensure that no particulates build u
Page 135 and 136: 118 Figure 7.26: Optical layout of
Page 137 and 138: The error signal shows three lines,
Page 139 and 140: into the CO2 laser. The optical lay
Page 141 and 142: Thorlabs PDA10A Coupler ZDC-10-1 to
Page 143 and 144: Imaging ber Imaging ber from Imagin
Page 145 and 146: Table 7.4 summarizes the beam power
Page 147 and 148: CO2 laser 40 MHz AOM f=2 in f=2 in
Page 149 and 150: 132 Figure 7.38: Optical layout aro
Page 151 and 152: Feshbach coil objective lenses atom
Page 153 and 154: MOT beams are no longer traveling a
Page 155 and 156: The second card (NI6733) offers eig
Page 157 and 158: Averaging over the magnetic subleve
Page 159 and 160: 2 2 P 3/2 D 2=670.977nm 2 2 S 1/2 m
Page 161 and 162: The right hand side of equation 7.1
Page 163 and 164: = E0 1 −n2 √2 exp σ0 ± iE0
Page 165 and 166: esidual potentials besides gravitat
Page 167 and 168: Figure 8.1: MOT loading. Typical lo
Page 169: A linear ramp typically changes the
Page 173 and 174: ubidium [113-115] and cesium[116].
Page 175 and 176: that most of the noise is due to th
Page 177 and 178: (a) (c) y . x z X=0.0mm Z=2.5mm 1)
Page 179 and 180: Figure 8.11: Different shapes of MO
Page 181 and 182: ZnSe lens f=5 in knife edge ZnSe wi
Page 183 and 184: shown in figure 8.13. By matching t
Page 185 and 186: Figure 8.15: Atom number and temper
Page 187 and 188: 275 Hz. Using these values the beam
Page 189 and 190: system. Maybe the easiest way to ac
Page 191 and 192: Appendix A Magic Wavelength of Hydr
Page 193 and 194: transitions for the excited state p
Page 195 and 196: Bibliography [1] J.J. Thomson. Cath
Page 197 and 198: [22] C.J. Foot. Atomic Physics. Oxf
Page 199 and 200: [46] E.D. Black. An introduction to
Page 201 and 202: [67] J.L. Hanssen. Controlling Atom
Page 203 and 204: [88] D.S. Naik, C.G. Peterson, A.G.
Page 205 and 206: [110] J.W. Goodman. Introduction to
Page 207: [132] C. Degenhardt, H. Stoehr, U.
show all

Experiments to Control Atom Number and Phase-Space Density in ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?