Precious Metals Recovery LLC RCRA Permit Application Dry Hills ...
Precious Metals Recovery LLC RCRA Permit Application Dry Hills ... Precious Metals Recovery LLC RCRA Permit Application Dry Hills ...
PMR Monthly, Quarterly, and Annually Inspection Form #4 Date: Time: Inspector: Other Inspections Warning Signs – Inspect for damage or vandalism Fire Extinguishers – Ensure proper functioning, that inspections and tests have been performed and ensure that they are readily available. Testing Fire Suppression Equipment Annual Testing Fire Suppression Flow Safety and Emergency Response Equipment – Ensure that they are readily available. Structural Condition of Tanks – Inspect for excessive damage that might cause unit failure. Associated Piping – Inspect all piping for evidence of damage or leakage. Ensure that they are all structurally sound. Equipment and Inventory Supply Parking Areas Load/Unload Docks – Ensure that safety rails are secure. Inspect for signs of spillage or litter. Ensure good housekeeping is maintained. Quarterly Check Monitoring Wells – Ensure the structural integrity of the well casings, seals, and well cap. Inspect for Sat. Unsat. Inspection Forms Precious Metals Recovery LLC March 2013
damage or vandalism. Other Inspections Sat. Unsat. Any items that have been determined to be “unsatisfactory” will be noted below. If corrective action is performed, include the type of action taken, the date completed, and the individual performing the action. Corrective action will be tracked on this form. Inspection Forms Precious Metals Recovery LLC March 2013
- Page 363 and 364: METHOD 1311 (CONTINUED) TOXICITY CH
- Page 365 and 366: Designation: D4979 − 08 Standard
- Page 367 and 368: Designation: D4978 − 95 (Reapprov
- Page 369 and 370: FIG. 1 Method B, Sulfide Test Appar
- Page 371 and 372: TABLE 1 Determination of Bias, Pycn
- Page 373 and 374: for four known specific gravity lev
- Page 375 and 376: 21.7.1 To check the precision of sa
- Page 377 and 378: Designation: D4981 − 08 Standard
- Page 379 and 380: Designation: D5058 − 12 Standard
- Page 381 and 382: 11.6.1 Compare the temperature here
- Page 383 and 384: APPENDIX 2-E Characterization Data
- Page 385 and 386: 5. Fire-fighting measures General I
- Page 387 and 388: Carcinogenicity: CAS# 10112‐91‐
- Page 393 and 394: Combined Hazen Solution Analysis pH
- Page 395 and 396: irritation and possible burns. May
- Page 397 and 398: OSHA Vacated PELs: Mercury: 0.05 mg
- Page 399 and 400: Chemical waste generators must dete
- Page 401 and 402: APPENDIX 4-A Inspection Plan
- Page 403 and 404: 1 INSPECTION PLAN This Inspection P
- Page 405 and 406: Inspections are intended to detect
- Page 407 and 408: Boilers and Industrial Furnaces Ins
- Page 409 and 410: PMR Daily Inspection Form #1 Date:
- Page 411 and 412: PMR Daily Inspection Form #2 Date:
- Page 413: PMR Weekly Inspection Form #3 Date:
- Page 417 and 418: TABLE OF CONTENTS 1 CONTINGENCY PLA
- Page 419 and 420: Potential Emergency Condition Fire,
- Page 421 and 422: Other duties of the emergency coord
- Page 423 and 424: Determine proper storage and placem
- Page 425 and 426: Neoprene boots - protect feet. Res
- Page 427 and 428: Fire Extinguishers. Absorbent pads
- Page 429 and 430: Table 2: Coordinating Agency Contac
- Page 431 and 432: Stay low in smoke filled areas. Co
- Page 433 and 434: the area or the National Response C
- Page 435 and 436: Description of the spilled material
- Page 437 and 438: APPENDIX 6-B Emergency Coordinators
- Page 439: Ambulance EXTERNAL CONTACTS Name Ti
PMR<br />
Monthly, Quarterly, and Annually Inspection Form #4<br />
Date: Time:<br />
Inspector:<br />
Other Inspections<br />
Warning Signs – Inspect for damage or vandalism<br />
Fire Extinguishers – Ensure proper functioning, that inspections<br />
and tests have been performed and ensure that they are readily<br />
available.<br />
Testing Fire Suppression Equipment<br />
Annual Testing Fire Suppression Flow<br />
Safety and Emergency Response Equipment – Ensure that they<br />
are readily available.<br />
Structural Condition of Tanks – Inspect for excessive damage<br />
that might cause unit failure.<br />
Associated Piping – Inspect all piping for evidence of damage<br />
or leakage. Ensure that they are all structurally sound.<br />
Equipment and Inventory Supply<br />
Parking Areas<br />
Load/Unload Docks – Ensure that safety rails are secure.<br />
Inspect for signs of spillage or litter. Ensure good housekeeping<br />
is maintained.<br />
Quarterly Check Monitoring Wells – Ensure the structural<br />
integrity of the well casings, seals, and well cap. Inspect for<br />
Sat. Unsat.<br />
Inspection Forms<br />
<strong>Precious</strong> <strong>Metals</strong> <strong>Recovery</strong> <strong>LLC</strong> March 2013
Change language