TDP-459 Users Guide - MItsubishi Imaging

1.2 Handling the Thermal Digiplater
- 3 -
Chapter 1 Safety Precautions
Pay attention to the following warnings and caution when handling the Thermal Digiplater:
Take the Thermal Digiplater out of the package and place it on a horizontal and stable
table or desk.
As it weighs approximately 55 kg (121lbs), it is dangerous for a single person to try to
hold or carry the Thermal Digiplater. When taking it out of the package, take care not to
injure your fingers or hands.
The Thermal Digiplater’s center of gravity is at the front. Take care not to lose balance
when carrying it. At least 3 persons are required to carry and install it.
Use extreamly caution when carrying it on a slippery floor.
If it is dropped and damaged, turn off the power switch on the main body, disconnect the
power cable from the electric oulet and contact the distributor. If it is used without
servicing, it can cause a fire or electric shock.
Plug the power cable all the way into the electric oulet.
The thermal head is heated while the Thermal Digiplater is operating. This is not an
abnormal phenomenon. It is heated to a high temperature. Never touch it.
If an abnormality occurs, take only the measures for the abnormalities described in this
users manual. If normal operation cannot be recovered, contact the distributor from
whom you bought it.
TDP-459