TDP-459 Users Guide - MItsubishi Imaging

More documents

Recommendations

Info

5.5 When power is off during printing Power outage Power cable accidentally disconnected - 51 - Chapter 5 Troubleshooting If power is off during printing, the thermal head remains pressed to the platen roller. Leaving this condition uncorrected for an extended period may cause deformation of the rubber on the platen roller. To prevent the rubber from being deformed, perform the following steps as instructed below. 1. Turn off the power switch and restore the power supply. [Useful tip] In case of a power outage, wait until the power supply service is restored. If the power cable is disconnected, re-connect the power cable to the power supply terminal or the electric outlet. When power is off during printing, the thermal head remains pressed to the platen roller and it is hard to put opening lever A and upper cover in motion. Put them in motion more strongly than usual. 2. Turn on the power switch. When turning on the power switch and the ready state is not displayed, it is thought that upper cover is not closed completely. Push the corners of the upper cover strongly (see the photo on the right) until clicking noise can be heard. 3. If “Plate Jam” is displayed on the LCD on the operation panel, follow the instructions as described in 5.2 Plate jam. Opening lever A Power switch Upper cover TDP-459
Chapter 6 After-sales service Chapter 6 After-sales service If you would like to inquire about the product or request a repair, please consult the distributor from whom you bought the product. TDP-459 - 52 -
Page 2:
Introduction Thank you for purchasi
Page 5 and 6: Table of Contents Chapter 5 Trouble
Page 7 and 8: Chapter 1 Safety Precautions 1.1 Ca
Page 9 and 10: Chapter 1 Safety Precautions Use on
Page 11 and 12: Chapter 1 Safety Precautions 1.4 Ha
Page 13 and 14: Chapter 2 Installation and Setup Ch
Page 15 and 16: Chapter 2 Installation and Setup 2.
Page 17 and 18: Chapter 2 Installation and Setup I
Page 25 and 26: Chapter 2 Installation and Setup 11
Page 29 and 30: Chapter 3 Use of Operation Panel TD
Page 31 and 32: Chapter 3 Use of Operation Panel 3.
Page 43 and 44: Chapter 4 Daily Maintenance Chapter
Page 45 and 46: Chapter 4 Daily Maintenance < Clean
Page 47 and 48: Chapter 4 Daily Maintenance 4.2 Cle
Page 49 and 50: Chapter 5 Troubleshooting Chapter 5
Page 51 and 52: Chapter 5 Troubleshooting When the
Page 53 and 54: Chapter 5 Troubleshooting 5.3 When
Page 55: Chapter 5 Troubleshooting 3. Wipe t
Page 59 and 60: Chapter 7 Specification Chapter 7 S
show all

TDP-459 Users Guide - MItsubishi Imaging

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?