TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5.5 When power is off during printing<br />
Power outage<br />
Power cable accidentally disconnected<br />
- 51 -<br />
Chapter 5 Troubleshooting<br />
If power is off during printing, the thermal head remains pressed to the platen roller. Leaving this<br />
condition uncorrected for an extended period may cause deformation of the rubber on the platen roller.<br />
To prevent the rubber from being deformed, perform the following steps as instructed below.<br />
1. Turn off the power switch and restore the<br />
power supply.<br />
[Useful tip]<br />
In case of a power outage, wait until the power supply service is restored. If the<br />
power cable is disconnected, re-connect the power cable to the power supply<br />
terminal or the electric outlet.<br />
When power is off during printing, the<br />
thermal head remains pressed to the<br />
platen roller and it is hard to put opening<br />
lever A and upper cover in motion. Put<br />
them in motion more strongly than usual.<br />
2. Turn on the power switch.<br />
When turning on the power switch and the<br />
ready state is not displayed, it is thought<br />
that upper cover is not closed completely.<br />
Push the corners of the upper cover<br />
strongly (see the photo on the right) until<br />
clicking noise can be heard.<br />
3. If “Plate Jam” is displayed on the LCD on<br />
the operation panel, follow the instructions<br />
as described in 5.2 Plate jam.<br />
Opening lever A<br />
Power switch<br />
Upper cover<br />
<strong>TDP</strong>-<strong>459</strong>