TDP-459 Users Guide - MItsubishi Imaging

More documents

Recommendations

Info

5.2 Plate jam If a plate jam occurs, turn off the power and remove the jammed plate. 1. Turn off the power switch. 2. By holding the opening lever on the top of the upper cover, open the upper cover to check the plate condition. If there is no plate left, go to When there is no plate left (page 46). If there is plate left, go to When there is plate left (page 47). Do not open the plate cover extremely quickly or forcibly 90 degrees or more. The thermal head is hot just after printing. Do not touch it directly by hand. Fingerprints on the thermal head heating element can cause the thermal head to fail. Do not touch it directly by hand. Be careful not to be injured by protrusions in the Thermal Digiplater. - 45 - Power switch Upper cover Chapter 5 Troubleshooting Opening lever TDP-459
Chapter 5 Troubleshooting When there is no plate left 1. Turn on the power switch. 2. Reset the plate. See 2.8 Setting the plate. TDP-459 - 46 - Power switch
Page 2: Introduction Thank you for purchasi
Page 5 and 6: Table of Contents Chapter 5 Trouble
Page 7 and 8: Chapter 1 Safety Precautions 1.1 Ca
Page 9 and 10: Chapter 1 Safety Precautions Use on
Page 11 and 12: Chapter 1 Safety Precautions 1.4 Ha
Page 13 and 14: Chapter 2 Installation and Setup Ch
Page 15 and 16: Chapter 2 Installation and Setup 2.
Page 17 and 18: Chapter 2 Installation and Setup I
Page 25 and 26: Chapter 2 Installation and Setup 11
Page 29 and 30: Chapter 3 Use of Operation Panel TD
Page 31 and 32: Chapter 3 Use of Operation Panel 3.
Page 43 and 44: Chapter 4 Daily Maintenance Chapter
Page 45 and 46: Chapter 4 Daily Maintenance < Clean
Page 47 and 48: Chapter 4 Daily Maintenance 4.2 Cle
Page 49: Chapter 5 Troubleshooting Chapter 5
Page 53 and 54: Chapter 5 Troubleshooting 5.3 When
Page 55 and 56: Chapter 5 Troubleshooting 3. Wipe t
Page 57 and 58: Chapter 6 After-sales service Chapt
Page 59 and 60: Chapter 7 Specification Chapter 7 S

TDP-459 Users Guide - MItsubishi Imaging

Create successful ePaper yourself

Delete template?

Save as template?