TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5.2 Plate jam<br />
If a plate jam occurs, turn off the power and remove the jammed plate.<br />
1. Turn off the power switch.<br />
2. By holding the opening lever on the top of<br />
the upper cover, open the upper cover to<br />
check the plate condition.<br />
If there is no plate left,<br />
go to When there is no plate left<br />
(page 46).<br />
If there is plate left,<br />
go to When there is plate left<br />
(page 47).<br />
Do not open the plate cover extremely<br />
quickly or forcibly 90 degrees or more.<br />
The thermal head is hot just after<br />
printing. Do not touch it directly by<br />
hand.<br />
Fingerprints on the thermal head<br />
heating element can cause the<br />
thermal head to fail. Do not touch it<br />
directly by hand.<br />
Be careful not to be injured by<br />
protrusions in the Thermal Digiplater.<br />
- 45 -<br />
Power switch<br />
Upper cover<br />
Chapter 5 Troubleshooting<br />
Opening lever<br />
<strong>TDP</strong>-<strong>459</strong>