TDP-459 Users Guide - MItsubishi Imaging

- 35 -
Chapter 3 Use of Operation Panel
3.3.6 Display of Plate Remains, and Reset of Plate Remains Counter
Display of plate remains and reset of plate remains counter are executed as follows.
When reset is executed, plate remains counter is 75m at the time of brand-new plate, and
printed length is subtracted in increments of 1m until reset is executed next time.
1. In the ready state, press the menu button
once, press the + button 5 times, and
display ”Plate” on the LCD.
[Useful tip]
Pressing the + or - button repeatedly changes the message on the LCD as
shown below.
2. Press the enter button, and display the
remains of the plate.
3. Press the enter button to come to the state
which can reset remains of the plate.
4. Press the enter button to reset remains of the
plate.
Press the clear button when not resetting.
5. Press the clear button repeatedly until the
ready state is displayed.
Plate
Plate m
Reset?
Plate 75m
TDP-459