TDP-459 Users Guide - MItsubishi Imaging

5. Press the enter button to select the operation
for setting the state (on/off) of head cleaning
mode.
6. Press the clear button repeatedly until the
ready state is displayed.
- 33 -
Chapter 3 Use of Operation Panel
Setup of the cleaning length
The length of the black bar printed at the time of head cleaning execution is changed as follows.
1. In the ready state, press the menu button
once, press the + button 4 times, and
display ”Head Cleaning” on the LCD.
Head Cleaning
2. Press the enter button once, press the +
button once, and display ”Cleaning Length”
on the LCD.
3. Press the enter button, and display the
setting state of cleaning length.
4. Press the + or - button to change the setting of
the cleaning length.
Cleaning Swon
Cleaning Length
Cleaning Length 10
Cleaning Length 50
Useful tip
It can be set from 10mm to 50mm in increments of 1mm.
When the setting value is enlarged, the effect of head cleaning becomes large,
but cleaning time becomes long.
TDP-459