TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3. Tighten the screw and fix flange.<br />
Turn in the direction of the illustration arrow,<br />
applying a finger to the knob part of the fixed screw.<br />
Please fasten securely, turning until the screw stops.<br />
<br />
Flange set position and the relation of the range which can be printed<br />
The plate end position at the time of setting a flange to 5<br />
When it sets to 4<br />
When it sets to 3<br />
When it sets to 2<br />
Range which can be printed<br />
<br />
Print start side<br />
Example: The relation of the plate<br />
and the range which can be<br />
printed in the case of setting a<br />
flange to "2" and using a plate with<br />
a width of 396mm.<br />
- 23 -<br />
Chapter 2 Installation and Setup<br />
The relation of a flange set position and the range which can be printed is shown<br />
in the following figure. When using custom-made size, it prints after confirming<br />
the range to a plate which can be printed.<br />
When it sets to 1<br />
When it sets to the innermost part.<br />
”no-number”<br />
<br />
<br />
<br />
<strong>TDP</strong>-<strong>459</strong>
Change language