TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2 Installation and Setup<br />
2.9 Change Method of Flange Position<br />
Please change the flange position of a spool according to the size of the plate to be used.<br />
1. Loosen the screw which secures the<br />
flange.<br />
<strong>TDP</strong>-<strong>459</strong><br />
Turns in the direction of the illustration arrow,<br />
applying a finger to the knob part of the fixed screw.<br />
2. Flange is set at the position<br />
corresponding to plate size.<br />
<br />
<br />
Please confirm the relation between plate size<br />
and a flange position using table on the right.<br />
Please unite the field of a flange inner side<br />
with the line described at the spool shaft.<br />
<br />
<br />
Flange<br />
The field of a flange inner side meets with a line.<br />
Example: When setting to flange position "2" The line<br />
on the left-hand side of number "2" and the<br />
field of a flange inner side should line up.<br />
- 22 -<br />
Spool shaft<br />
Flange position<br />
with no number<br />
Plate size<br />
.When using B*52 made from Hamada