TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 2 Installation and Setup<br />
5. Take out the new plate from the black<br />
polybag.<br />
<strong>TDP</strong>-<strong>459</strong><br />
The plate weighs approx. 10 kg (22 lbs).<br />
Handle it carefully so as not to drop it.<br />
Dropping it is dangerous.<br />
6. Change the flange (gear side) position of<br />
the spool according to the size of the plate<br />
to be used.<br />
Please refer to "2.9 The change method of flange position."<br />
7. Insert the shaft of the spool into the core of<br />
the plate and gently force the flange (gear<br />
side) of the spool on the side of the plate.<br />
[Useful tip]<br />
When inserting the shaft of the spool into the core of the plate, place the<br />
plate so that the lead edge of the winding plate is upward. Then, insert the<br />
shaft of the spool from the right-hand side.<br />
- 18 -<br />
Plate<br />
Work table<br />
Lead edge of the winding plate<br />
Flange (gear side)<br />
Spool<br />
(Flange (gear side))<br />
The direction<br />
which inserts<br />
a shaft<br />
As the outer diameter of the flange is larger than the outer diameter of the<br />
plate, it is recommended that this work is performed with the right-hand side<br />
of the plate protruding from the work table.