TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2.6 Connecting the USB cable<br />
1. Connect the USB cable connected to your<br />
PC to the USB terminal at the back of the<br />
Thermal Digiplater.<br />
- 15 -<br />
Chapter 2 Installation and Setup<br />
When moving the Thermal Digiplater, disconnect the power cable from the electric<br />
outlet and make sure that all external connecting lines have been disconnected.<br />
If a cord is kept connected, it can be scratched, and a fire or electric shock can<br />
occur, or you can trip and be injured.<br />
If the Thermal Digiplater is not used for a long time, disconnect the power cable<br />
from the electric outlet for safety.<br />
Do not connect the power cable to an electric outlet to which other cords are<br />
connected. Requires a dedicated electric outlet.<br />
Doing so can cause a fire or electric shock.<br />
USB cable<br />
[Product compatible with USB<br />
2.0 standard]<br />
Thermal Digiplater side is a type B connector (square).<br />
Use only the USB cable supplied with the product or a specified one. If a cable other<br />
than the supplied cable is used, incorrect printing can result.<br />
Before disconnecting the USB cable, make sure that the Thermal Digiplater<br />
is in the standbystate. If disconnected during data transfer, the Thermal<br />
Digiplater can be damaged.<br />
<strong>TDP</strong>-<strong>459</strong>