TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
TDP-459 Users Guide - MItsubishi Imaging
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2 Installation and Setup<br />
2.5 Connecting the power cable<br />
Connect the power cable by observing the following instructions:<br />
1. Insert the power cable supplied into the<br />
power input terminal at the back of the<br />
Thermal Digiplater.<br />
<strong>TDP</strong>-<strong>459</strong><br />
Power cable<br />
Before connecting the power cable, make sure that the power switch is off.<br />
Use only the power cable supplied with the product or a specified one.<br />
Be sure to connect the power cable to the electric outlet to be grounded according<br />
to all relevant local regulations (resistance:less than 100 ohm)). If a short circuit<br />
occurs while the Thermal Digiplater is operating without being grounded, a fire or<br />
electric shock can occur. If the Thermal Digiplater cannot be grounded, consult the<br />
distributor.<br />
Plug the power cable all the way into the electric outlet.<br />
Failure to do so can cause a fire or failure.<br />
Do not connect or disconnect the power cable with wet hands.<br />
Doing so can cause an electric shock.<br />
Do not scratch, damage or rework the power cable.<br />
Do not put a heavy article on the cable. Do not pull or forcibly bend it.<br />
Doing so can damage the power cable and cause a fire or electric shock.<br />
- 14 -