Instant Reverse - Visual Paradigm

SDE-VS User’s Guide (Part 1) Chapter 2 –Working with Diagrams
2-22
• Right-click on the target diagram and choose Open Specification from popup menu. This displays the Diagram
Specification dialog box. From the dialog box, switch to Grid Setting tab and check/uncheck Snap to Grid to turn
on/off the snap to grid option.
Figure 2.53 - Check Snap to grid in Specification
Grid Size
To adjust the grid size, perform one of the following actions:
• From the property table, enter the value for Width and Height property under Grid heading.
Figure 2.54 - Adjust grid size in property table
• Right-click on the target diagram and choose Open Specification from popup menu. This displays the Diagram
Specification dialog box. From the dialog box, switch to Grid Setting tab and enter the value for Width and Height.