om, rz3016, 2009-04, 966042901, zero turn, consumer - Husqvarna

More documents

Recommendations

Info

Open the fuel valve. Press in and turn the ignition key to the start position When the engine starts, immediately release the ignition key back to the run position. IMPORTANT INFORMATION Do not run the starter for more than 5 seconds each time. If the engine does not start, wait approximately 10 seconds before retrying. 26 - HUSQVARNA OPERAtION Open the fuel valve STOP Turn to START position STOP Release ignition to the RUN position 8050-010 8050-135 8050-136
Slowly slide the choke control back to the middle position when the engine has started. Set the desired engine speed with the throttle. Allow the engine to run at a moderate speed, “half throttle” for 3-5 minutes before loading it to heavily. USE FULL THROTTLE WHEN MOWING (no choke). Weak Battery WARNING! Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects, or other reproductive system damage. The engine exhaust contains carbon monoxide, which is a odorless, colorless, poisonous gas. Do not use the machine in enclosed spaces. WARNING! Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries. If your battery is too weak to start the engine, it should be recharged. (See “Battery” in the Maintenance Section.) If “jumper cables” are used for emergency starting, follow this procedure: Jumper cables • Connect each end of the RED cable to the POSItIVE (+) terminal on each battery, taking care not to short against chassis. • Connect one end of the BLACK cable to the NEGAtIVE (-) terminal of the fully charged battery. • Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery. To remove cables, reverse order • Remove BLACK cable first from chassis and then from the fully charged battery. • Remove RED cable last from both batteries. OPERAtION Use full throttle when mowing IMPORTANT INFORMATION Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower to start other vehicles. Jumper cable connection 8050-007 8011-642 HUSQVARNA-27
Page 1 and 2: RZ 3016 Operator Manual 966042901 P
Page 3 and 4: INtRODUCtION ......................
Page 5 and 6: Congratulations thank you for purch
Page 7 and 8: these symbols are found on the mach
Page 9 and 10: WARNING! THIS CUTTING MACHINE IS CA
Page 11 and 12: Personal Safety Equipment • •
Page 13 and 14: Safe Handling of Gasoline to avoid
Page 15 and 16: • • • • • • • • •
Page 17 and 18: this operator’s manual describes
Page 19 and 20: Parking Brake the parking brake is
Page 21 and 22: Fuel Shut Off Valve the fuel shut o
Page 23 and 24: Read “Safety Instructions” sect
Page 25: Move the steering controls outward
Page 29 and 30: Operating on Hills Read the Safety
Page 31 and 32: Stopping the Engine Allow the engin
Page 33 and 34: Maintenance Schedule the following
Page 35 and 36: Battery Your mower is equipped with
Page 37 and 38: Engine Cooling Air Intake Check tha
Page 39 and 40: EZT Belt To replace EZT belt Park t
Page 41 and 42: Caster Wheels Check every 200 hours
Page 43 and 44: Front Wheel Mount Lubricate with a
Page 45 and 46: Checking the Oil Level the importan
Page 47 and 48: tROUBLESHOOtING Problem Cause the e
Page 49 and 50: Winter Storage At the end of the mo
Page 51 and 52: Engine crankshaft bolt 50 ft/lb (67
Page 53 and 54: Frame tECHNICAL DAtA RZ3016 / 96604
Page 55 and 56: SERVICE JOURNAL Action Date, mtr re
Page 64: P/N 115 161426 IR 04/02/09

om, rz3016, 2009-04, 966042901, zero turn, consumer - Husqvarna

Create successful ePaper yourself

Delete template?

Save as template?