product guide - M-Audio
product guide - M-Audio
product guide - M-Audio
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PRODUCT GUIDE 2009<br />
80<br />
PRODUCT SPECIFICATIONS<br />
SPECIFICATIONS<br />
Please visit m-audio.com for additional <strong>product</strong> information. All<br />
specifi cations are measured at 48kHz sampling rate unless<br />
otherwise stated.<br />
Aries<br />
Type:<br />
handheld small-diaphragm condenser<br />
Pattern: cardioid<br />
Frequency Response: 20Hz to 20kHz<br />
Preamp Topology: class A FET, transformerless<br />
Sensitivity: 13.8mV/Pa (-37dBV re 1V/Pa)<br />
Max SPL for 0.5% THD: 134dB SPL<br />
Equivalent Noise Level: 17dB A-weighted<br />
Output Impedance: 200 ohms<br />
Recommended Load<br />
Impedance: >1,000 ohms<br />
Connector: 3-pin male XLR<br />
Power Requirement: 48V phantom power<br />
Dimensions: 6.60” (168 mm) x 1.57” (40 mm)<br />
Weight: .58 lbs (.26 kg)<br />
<strong>Audio</strong> Buddy<br />
Mic Inputs (analog)<br />
Max Gain: >60dB<br />
Frequency Response: 20 to 50kHz, +/-1dB<br />
Max Input levels:<br />
-18dBu @ min gain, -37dBu @ max gain<br />
Signal-to-Noise Ratio,<br />
Mid Gain: -95dB, A-weighted<br />
Dynamic Range, Mid Gain: 95dB, A-weighted<br />
THD+N, Mid Gain:<br />
0.021% (-73dB), 1dB below clipping, 22Hz to 22kHz<br />
EIN Noise Rating: -116dBu @ max gain, 150 ohm load,<br />
20kHz BW (unweighted)<br />
Phantom Power: yes<br />
Instrument Inputs (analog)<br />
Max Gain: 40dB<br />
Frequency Response,<br />
Min Gain: 20Hz to 50kHz, +/-0.1dB<br />
Signal-to-Noise Ratio,<br />
Min Gain: -104dB, A-weighted<br />
Dynamic Range, Min Gain: 104dB, A-weighted<br />
THD+N, Min Gain:<br />
0.007% (-83dB), 1dB below clipping, 22Hz to 22kHz<br />
<strong>Audio</strong>phile 192<br />
Line Inputs (A/D)<br />
Impedance:<br />
20k ohms balanced, 10k ohms unbalanced<br />
Max Input Level:<br />
+14.2dBu (4 Vrms), balanced/unbalanced<br />
Channel-to-Channel<br />
Crosstalk: