Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MIDI Page<br />
In the MIDI page you can activate or deactivate the MIDI input and MIDI output<br />
devices separately by using the two Enable checkboxes. Remember that changes<br />
will only take effect after rebooting Windows.<br />
There are three states a MIDI device may enter: Closed, Paused and Playing. If a<br />
MIDI device is not in use it is Closed. Paused MIDI devices are not actually playing.<br />
Playing indicates that a MIDI device is in use by an application. In that case MIDI<br />
Bytes counts up with every byte transferred by the driver.<br />
To obtain MIDI Machine Control and ADAT Time Code in<strong>for</strong>mation, connect an<br />
ADAT recorder with an ADAT Sync cable to the LAGOON and choose ADAT Sync<br />
In (General page). The transport field and the time display then always will show the<br />
current status of your ADAT recorder. Assuming Input device is enabled, Time Code<br />
synchronization is possible now. Since ADAT recorders do not accept MIDI data<br />
coming from an application, the Output device will be ignored in this mode.<br />
Hint: For proper MIDI timing always make sure the LAGOON is running at a valid<br />
sample rate (Output error light in the Status page should be turned off).<br />
Status Page<br />
The Status page will give you in<strong>for</strong>mation about the actual state of the LAGOON<br />
card. The upper part of this page contains 4 groups of possible error messages: Input<br />
Errors, Output Error, MIDI Errors and General Errors. By checking the boxes on<br />
the left side of the error light you can determine if the corresponding error will be<br />
evaluated or if it will be ignored. If you check a box and the corresponding error<br />
occurs, the red error light will turn on. If any of the error lights on this page is turned<br />
on, the light on top of the Status page and the LAGOON icon in the Windows taskbar<br />
will start blinking. This way you can see if something is wrong with your LAGOON<br />
without always having the Status page on top of your desktop.<br />
19