Enterprise QoS Solution Reference Network Design Guide

Chapter 3 WAN Aggregator QoS Design
Version 3.3
no atm ilmi-keepalive
!
interface ATM3/IMA0.12 point-to-point
ip address 10.6.12.1 255.255.255.252
pvc 0/100
vbr-nrt 3072 3072 ! ATM PVC speed expanded
max-reserved-bandwidth 100 ! Overrides the default 75% BW limit
service-policy output WAN-EDGE ! Attaches MQC policy to PVC
!
!
Verification commands:
show policy map
show policy-map interface
show atm pvc
show ima interface atm
Verification Command: show ima interface atm
WAN Edge Link-Specific QoS Design
The show ima interface atm command is useful for verifying that all members of an ATM IMA group
are active. See Example 3-32.
Example 3-32 show ima interface atm Verification of ATM IMA Group
WAG-7206-Left#show ima interface atm 3/ima0
Interface ATM3/IMA0 is up
Group index is 1
Ne state is operational, failure status is noFailure
Active links bitmap 0x3
IMA Group Current Configuration:
Tx/Rx configured links bitmap 0x3/0x3
Tx/Rx minimum required links 1/1
Maximum allowed diff delay is 25ms, Tx frame length 128
Ne Tx clock mode CTC, configured timing reference link ATM3/0
Test pattern procedure is disabled
IMA Group Current Counters (time elapsed 257 seconds):
0 Ne Failures, 0 Fe Failures, 0 Unavail Secs
IMA Group Total Counters (last 5 15 minute intervals):
0 Ne Failures, 0 Fe Failures, 0 Unavail Secs
IMA link Information:
Link Physical Status NearEnd Rx Status Test Status
---- --------------- ----------------- -----------
ATM3/0 up active disabled
ATM3/1 up active disabled
ATM3/2 administratively down unusableInhibited disabled
ATM3/3 administratively down unusableInhibited disabled
Very-High-Speed (DS3-OC3+) ATM Links
Recommendation: Use newer hardware platforms and keep an eye on CPU levels.
Enterprise QoS Solution Reference Network Design Guide
3-39