CCNP TSHOOT 6.0 - Cisco Learning Home

CCNPv6 TSHOOT
Step 4: Reload the device, but do not save the system configuration if prompted.
ALS1#reload
System configuration has been modified. Save? [yes/no]: no
Proceed with reload? [confirm]
*Oct 1 00:29:28.704: %SYS-5-RELOAD: Reload requested by console. Reload
Reason: Reload command.
Step 5: When the device restarts, do not enter the initial configuration dialog, but terminate
autoinstall if prompted.
Press RETURN to get started!
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Would you like to terminate autoinstall? [yes]: Enter
Step 6: Copy the specified lab device configuration file from flash to the running config.
Switch>enable
Switch#copy flash:/tshoot/Lab31-ALS1-Base-Cfg.txt running-config
Destination filename [running-config]? Enter
ALS1#
Note: Although it is possible to copy the file to the startup config and reload the device, the RSA keys for SSH
cannot be generated from the startup config.
Step 7: Copy the running config to the startup config.
Depending on the IOS version, AUTOSAVE may automatically save a copy of the running config to
NVRAM for startup.
Note: AUTOSAVE does not copy the line con and vty configurations from the running config to the
startup config. To ensure that the startup configuration is complete, you must copy manually.
ALS1#copy running-config startup-config
Building configuration...
[OK]
Note: If the device is rebooted at this point, you can log in with the username admin and the password
adminpa55. To access privileged EXEC mode, use the enable password of ciscoenpa55.
Step 8: Repeat Steps 1 through 7 for the other devices in the network.
Step 9: Configure the PCs.
a. Configure SRV1 with the static IP address 10.1.50.1/24 and the default gateway 10.1.50.254.
b. Configure PC-B and PC-C as DHCP clients.
All contents are Copyright © 1992–2010 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 5 of 38