CCNP TSHOOT 6.0 - Cisco Learning Home

CCNPv6 TSHOOT
Device Configuration File Table
Device Name File to Load Notes
ALS1 Lab71-ALS1-TT-B-Cfg.txt
DLS1 Lab71-DLS1-TT-B-Cfg.txt
DLS2 Lab71-DLS2-TT-B-Cfg.txt
R1 Lab71-R1-TT-B-Cfg.txt
R2 Lab71-R2-TT-B-Cfg.txt
R3 Lab71-R3-TT-B-Cfg.txt
SRV1 N/A Static IP: 10.1.50.1
Default gateway: 10.1.50.254
PC-B N/A Static IP: 10.1.80.254/24
Default gateway: 10.1.80.1
PC-C N/A DHCP
Step 3: Test R3 performance without the TTCP load generator.
Use Cisco IOS commands and pings to record the router performance figures simulating a condition in which
no large file transfers are currently being transmitted. These results can be compared to the baseline output
(selected baseline information is shown) and the output obtained when using the TTCP utility.
a. Ping from PC-B to R2 Lo1 (simulated remote server) and record the minimum, maximum, and
average round-trip times.
____________________________________________________________________________
C:\>ping 172.20.0.1
Pinging 172.20.0.1 with 32 bytes of data:
Reply from 172.20.0.1 : bytes=32 time=11ms TTL=64
Reply from 172.20.0.1 : bytes=32 time=10ms TTL=64
Reply from 172.20.0.1 : bytes=32 time=10ms TTL=64
Reply from 172.20.0.1 : bytes=32 time=10ms TTL=64
Ping statistics for 172.20.0.1 :
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 10ms, Maximum = 11ms, Average = 10ms
b. Issue the show interfaces fa0/0 command and note the txload and rxload information.
______________________________________________________________________________
R3#show interfaces fa0/0
FastEthernet0/0 is up, line protocol is up
Hardware is Gt96k FE, address is 001b.530d.6028 (bia 001b.530d.6028)
Internet address is 10.1.80.1/24
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
All contents are Copyright © 1992–2010 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 14 of 32