Stateful Switchover.pdf - Cisco Learning Home

Stateful Switchover
Stateful Switchover
Configuration Examples
Copying an Image onto the Active and Standby RPs on the Cisco 7304 and Cisco 10000 Example
This example copies an image to Flash memory on each of the PREs of a Cisco 7304 or Cisco 10000
series Internet router.
Cisco 7304 Example:
Router# copy tftp disk0:c7300-p-mz
Router# copy tftp stbydisk0:c7300-p-mz
Cisco 10000 Example
Router# copy tftp disk0:c10k-p10-mz
Router# copy tftp stby-disk0:c10k-p10-mz
The system will prompt you for additional server and filename information for each copy command.
Copying an Image onto Active and Standby RPs on the Cisco 12000 Example
This example copies an SSO-aware software image to Flash memory on each GRP of a Cisco 12000
series Internet router.
Router# copy tftp slot0:gsr-p-mz
Router# copy tftp stby-slot0:gsr-p-mz
The system will prompt you for additional server and filename information for each copy command.
Setting the Configuration Register Boot Variable Examples
The examples in this section configure the configuration register boot variable to boot from Flash and
then reload each of the RPs with the new image:
This section includes the following examples:
• Setting the Configuration Register Boot Variable on the Cisco 7304 Example
• Setting the Configuration Register Boot Variable on the Cisco 7500 Example
• Setting the Configuration Register Boot Variable on the Cisco 10000 Example
• Setting the Configuration Register Boot Variable on the Cisco 12000 Example
Setting the Configuration Register Boot Variable on the Cisco 7304 Example
This example sets the configuration register boot variable to boot from Flash and then reload each of the
RSPs with the new image.
Router# show version
Router# configure terminal
Router(config)# no boot system flash disk0:
Router(config)# boot system flash disk0:c7300-js-mz
Router(config)# config-register 0x2101
Router(config)# exit
Router# copy running-config startup-config
Router# reload
39