Stateful Switchover.pdf - Cisco Learning Home

Configuration Examples
Command Purpose
debug redundancy {all | ui | clk | hub}
Example:
Router# debug redundancy all
show diag [slot-number | chassis | subslot slot/subslot]
[details | summary]
Example:
Router# show diag
show redundancy [clients | counters | debug-log | handover |
history | switchover history | states | inter-device]
Example:
Router# show redundancy
show version
Example:
Router# show version
Configuration Examples
38
This section provides the following configuration examples:
• Copying an Image onto an RP Examples
• Setting the Configuration Register Boot Variable Examples
Stateful Switchover
• Configuring SSO Examples
• Configuring Autosync LMI Sequence Numbers: Example
Copying an Image onto an RP Examples
Stateful Switchover
The examples in this section copy an SSO-aware software image to Flash memory on each of the RPs.
This section includes the following examples:
• Copying an Image onto the Active and Standby RPs on the Cisco 7500 Example
• Copying an Image onto the Active and Standby RPs on the Cisco 7304 and Cisco 10000 Example
• Copying an Image onto Active and Standby RPs on the Cisco 12000 Example
Copying an Image onto the Active and Standby RPs on the Cisco 7500 Example
This example copies an image to Flash memory on each of the RSPs of a Cisco 7500 series router.
Router# copy tftp slot0:rsp-pv-mz
Router# copy tftp slaveslot0:rsp-pv-mz
Debugs redundancy on the networking device.
Displays hardware information for the router.
Displays the redundancy configuration mode of the
RP. Also displays information about the number of
switchovers, system uptime, processor uptime, and
redundancy state, and reasons for any switchovers.
Displays image information for each RP.
The system will prompt you for additional server and filename information for each copy command.