Stateful Switchover.pdf - Cisco Learning Home
Stateful Switchover.pdf - Cisco Learning Home
Stateful Switchover.pdf - Cisco Learning Home
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Stateful</strong> <strong>Switchover</strong><br />
Verifying SSO Configuration<br />
SUMMARY STEPS<br />
DETAILED STEPS<br />
Step 1 enable<br />
This task shows how to verify that SSO is configured on the networking device.<br />
<strong>Stateful</strong> <strong>Switchover</strong><br />
Configuration Tasks<br />
Note The output of these commands will vary based on your device configuration and system site<br />
requirements. For examples of command output, see<br />
1. enable<br />
2. show redundancy [clients | counters | debug-log | handover | history | switchover history |<br />
states | inter-device]<br />
3. show redundancy [clients | counters | debug-log | handover | history | switchover history |<br />
states | inter-device]<br />
Example:<br />
Router> enable<br />
Step 2 show redundancy [clients | counters | debug-log<br />
| handover | history | switchover history |<br />
states | inter-device]<br />
Example:<br />
Router# show redundancy<br />
Step 3 show redundancy [clients | counters | debug-log<br />
| handover | history | switchover history |<br />
states | inter-device]<br />
Example:<br />
Router# show redundancy states<br />
Performing a Fast Software Upgrade<br />
Enables privileged EXEC mode.<br />
• Enter your password if prompted.<br />
Verifies that SSO is configured on the networking device.<br />
Verifies that the device is running in SSO mode. The states<br />
keyword specifies whether the unit is running in SSO mode.<br />
The FSU procedure allows you to upgrade (or downgrade) the <strong>Cisco</strong> IOS image on the RPs. <strong>Cisco</strong> IOS<br />
software is upgraded on the standby RP, and a manual switchover is performed. The new <strong>Cisco</strong> IOS image<br />
can then be upgraded on the other RPs.<br />
Note During the upgrade process, different images will be loaded on the RPs for a very short period of time.<br />
If a switchover occurs during this time, the device will recover in HSA, RPR or RPR+ mode, depending<br />
on the networking device.<br />
31