IDAutomation SC4USB Barcode Scanner User Manual

Recommendations

Info

Group 5: Scan Mode ENTER GROUP 1: Trigger On/Off 3: Trigger On/Good Read Off/ Delay Timeout = ? 5: Continuous/LED Always on 7: Continuous/Testing 13 EXIT 2: Trigger On/Good Read Off (*) 4: Continuous/Trigger Off 6: Continuous/No Trigger 8: Continuous/Trigger Off/ Delay Timeout = ?
Group 5: Scan Mode ENTER GROUP FLASH OFF(*) SHORT ZONE LASER DELAY For Laser <strong>Scanner</strong> Mode Default Laser Delay Timeout = 60 sec. FLASH ON LONG ZONE Scan Enter Group 5 Label Scan Laser Delay --> Refer to the Table-Hex at page 41 and select a value --> Scan Confirm in Table Hex. Scan Exit Label LAG-960TR - Auto Trigger mode Scan Enter Group 5 Label --> AUTO TRIGGER EXIT Scan 8: Continuous/Trigger off/Delay timeout=? (Page 13) --> Scan two digit label and "confirm" label in Page 43 --> Scan Above "Auto Trigger Label) Switch on the LAG-960 bottom switch Note: Scan mode setting is only available for CCD/Laser type scanner. 14
Page 2 and 3: CONTENTS Getting Started ----------
Page 4 and 5: Setup Procedures 1) Locate a group
Page 6 and 7: Group 0: Interface Selection KEYBOA
Page 8 and 9: Group 1: Device Selection for Keybo
Page 10 and 11: Group 3: Language for Keyboard Inte
Page 12 and 13: Group 4: Terminator ENTER GROUP NON
Page 16 and 17: Group 6: Preamble and Postamble Pre
Page 18 and 19: Group 8: RS-232 Parameters NONE (*)
Page 20 and 21: Group 9: CODE 39 / (CODE 32) Enable
Page 22 and 23: Group 10-1: Interleaved 2 OF 5 Disa
Page 24 and 25: Group 10-3: Matrix 2 of 5 Disable (
Page 26 and 27: Group 11: CODE 128/(CODE 93)/(CODE
Page 28 and 29: Group 12: (ISBN/ISSN) ENTER GROUP D
Page 30 and 31: Group 14: (Code 4) ENTER GROUP Enab
Page 32 and 33: Group 15-2: UPC-A ENTER GROUP Enabl
Page 34 and 35: Group 15-4: UPC-E / UCC EAN/128 ENT
Page 36 and 37: Group 17: Code ID Setting ENTER GRO
Page 38 and 39: Group 19-1: (Magnetic Parameters) E
Page 40 and 41: Group 19-2: (Magnetic Parameters) S
Page 42 and 43: F1 ($A) F2 ($B) F3 ($C) F4 ($D) F5
Page 44 and 45: 0 2 4 6 8 A C E Confirm Table-Hex :
Page 46 and 47: Hexadecimal-Decimal Conversion Tabl
Page 48: PIN ASSIGNMENTS RS-232 Signal Outpu

IDAutomation SC4USB Barcode Scanner User Manual

Create successful ePaper yourself

Delete template?

Save as template?