Manual CEPR 96 - Balogh technical center
Manual CEPR 96 - Balogh technical center
Manual CEPR 96 - Balogh technical center
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
STOP the PROGRAM EXECUTION<br />
SYNTAX<br />
SYNTAX<br />
Hexadecimal : NC 06 00 05 04<br />
Hexadecimal :<br />
Mnemonic : INS,6,0.<br />
Mnémonic :<br />
EXECUTION<br />
Used to stop the program, to reset the program pointer to the origin line, and to reset<br />
EXECUTION<br />
the outputs ports. The board must be in BREAK mode before program down loading<br />
and/or program modification (It's automaticaly done with the <strong>CEPR</strong>-3W software).<br />
STEP by STEP PROGRAM EXECUTION<br />
COMMENTS<br />
SYNTAX<br />
Hexadecimal : NC 06 01 05 04<br />
Mnemonic : INS,6,1.<br />
EXECUTION SYMBOLS DEFINITION LIMITS<br />
Stop the program execution but doesn't reset anythings. Each STEP command allows<br />
to execute the automate program, the courent line and to increment the courent line<br />
number.<br />
EXAMPLE<br />
PAGE 7<br />
Instructions manual for <strong>CEPR</strong><strong>96</strong> / MRUC20 M97.10.01<br />
06 00<br />
BREAK<br />
06 01<br />
STEP<br />
NOTE :<br />
Inputs,outputs, and timers counters continue to be updated as the normal program<br />
execution.<br />
RUN the PROGRAM<br />
SYNTAX<br />
Hexadecimal : NC 06 02 05 04<br />
06 02<br />
RUN<br />
Mnemonic : INS,6,2.<br />
Start the program execution.<br />
Note : Put the board under power, allows an automatic RUN with the initials conditions<br />
define by the RMOD (05H) function.
Change language