HARMONIC REDUCTION IN POWER SYSTEM Ankit Vashi B.E. ...

More documents

Recommendations

Info

Figure 14 : Single Phase Inverter with Filter [6] Figure 15 shows output waveforms that gets produced based on the Pulse width modulation technique when it is employed. Figure 15 : Output waveforms Produced Based on PWM Technique [6] In a single phase inverter, the varying width of the output pulse is used to control the output voltage. Thus, this process of controlling the output voltage of inverter in 28
order to reduce the harmonics is known as Pulse Width Modulation. The Pulse Width Modulation is classified into two techniques. [6] • Non sinusoidal Pulse Width Modulation • Sinusoidal Pulse Width Modulation 4.3.2 Non Sinusoidal Pulse Width Modulation: In case of Non sinusoidal pulse width modulation, all the pulses that have same pulse width are modulated together. The pulse widths of pulses are adjusted together in same proportion on order to remove the harmonics from the system. A typical representation of Non sinusoidal pulse width modulation is shown in figure 16 shown below.[6] Figure 16 : Representation of Non Sinusoidal Pulse Width Modulation [6] 29
Page 1 and 2: HARMONIC REDUCTION IN POWER SYSTEM
Page 3 and 4: I certify that this student has met
Page 5 and 6: TABLE OF CONTENTS List of Figures
Page 7 and 8: LIST OF FIGURES 1. Figure 1: Single
Page 9 and 10: Chapter 1 INTRODUCTION The term har
Page 11 and 12: 2.2 Transients: In terms of power s
Page 13 and 14: obtained during the event is consid
Page 15 and 16: Non-linear loads are considered as
Page 17 and 18: an inductance is a passive filter.
Page 19 and 20: 3.2 Roles of Filters in Power Syste
Page 21 and 22: 3.3.1 Types of Passive Filters: The
Page 23 and 24: Figure 4 : Three Phase, Three Wire
Page 25 and 26: 3.4 Active Filters : Active filters
Page 27 and 28: Figure 9 : Single Phase Active Filt
Page 29 and 30: Theoretically the output voltage wa
Page 31 and 32: consists of four IGBT devices (also
Page 33 and 34: 4.2.3 Multi Level Inverters : Figur
Page 35: converters, the main objective is t
Page 39 and 40: Note: For figures 16 and 17, • ts
Page 41 and 42: Figure 18 : Plot of Switching angle
Page 47 and 48: cos(7*s1)-cos(7*s2)+cos(7*s3)-cos(7
Page 49: REFERENCES 1.) Roger C. Dugan, Mark

HARMONIC REDUCTION IN POWER SYSTEM Ankit Vashi B.E. ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?