Technical Product Specification for Canoe Pass - Preminary - Intel

Intel ® Server Board S2600CP and Server System P4000CP TPS Intel® Server Board S2600CP Functional Architecture
4.1 Processor Support
The server board includes two Socket-R (LGA2011) processor sockets and can support two
processors. The processor currently supported is - Intel ® Xeon ® processor E5-2600 product
family, code named “Sandy Bridge - EP” with a Thermal Design Power (TDP) of up to 130W.
Previous generation Intel ® Xeon ® processors are not supported on the Intel server boards
described in this document.
For a complete updated list of supported processors, see: On
the Support tab, look for Compatibility and then Supported Processor List.
4.1.1 Processor Socket Assembly
Each processor socket of the server board is pre-assembled with an Independent Latching
Mechanism (ILM) and Back Plate which allow for secure placement of the processor and
processor heat to the server board.
The illustration below identifies each sub-assembly component.
4.1.2 Processor Population Rules
Figure 15. Processor Socket Assembly
Note: Although the server board does support dual-processor configurations consisting of
different processors that meet the defined criteria below, Intel does not perform validation
testing of this configuration. For optimal system performance in dual-processor configurations,
Intel recommends that identical processors be installed.
When using a single processor configuration, the processor must be installed into the processor
socket labeled CPU1.
Revision 0.8 Intel Confidential
Intel order number G26942-003
Server Board
Heat Sink
When two processors are installed, the following population rules apply:
Independent Latching
Mechanism (ILM)
Back Plate
25