TRITON Extreme Operation Guide - Platinum Audiolab

Combination D062: Old Vox Organ
Although this is a somewhat sophisticated editing technique,
we will describe the settings of one of the preset
combinations as an example.
Select combination D062: Old Vox Organ, press the
ARPEGGIATOR [ON/OFF] key to turn it on, and play.
Before you play, make sure that the global MIDI channel
(Global P1: MIDI “MIDI Channel”) is set to 01.
• Arpeggiator A is assigned to T (timbre) 7 and 8. When
you play the keyboard, the arpeggio pattern
U396(User): Dr-Jump Up DnB will sound only the T7
program J068: HipHop Kit.
• The arpeggio pattern uses Fixed Note mode, which is
suitable for playing drums from the arpeggiator
(Global P6: User Arpeggio, Pattern Setup page
“Arpeggio Tone Mode” Fixed Note).
With this setting, the arpeggio pattern will always play
the specified pitches regardless of the note numbers
received from the keyboard. (☞PG p.171)
• The A “Bottom Key” and “Top Key” (Combination P7:
Edit-Arp., Scan Zone A/B page) are set so that
arpeggiator A will operate only for notes B3 and
lower.
• Arpeggiator A is also assigned to T8, but this is so that
the T7 program J068: HipHop Kit will sound only
when the arpeggiator is on.
Notice the timbre settings for T7 and T8
Status MIDI Channel Assign
T7 INT 02 A
T8 Off Gch A
• If the arpeggiator is off, playing the keyboard will
sound the timbre(s) that are set to Gch or to the global
MIDI channel (in this case, 01). Since the “MIDI
Channel” of T7 is set to 02, it will not sound. T8 is set
to Gch, but since “Status” is Off it will not sound.
• Any MIDI channel that is assigned to a timbre will
trigger the arpeggiator. In this case, these will be
“MIDI Channel” 02 and Gch (global MIDI channel).
When the arpeggiator is on, playing the keyboard will
trigger arpeggiator A which is assigned to T8 (Gch).
T7 will be sounded by arpeggiator A. Since the
“Status” of T8 is Off, it will not sound.
• Since the “Status” of T8 is Off, it will not sound,
regardless of whether the arpeggiator is on or off. It is
a dummy timbre that causes T7 to sound only when
the arpeggiator is on.
Combination J056: “In The Pocket”
Select and play combination J056: “In The Pocket.”
Before you play, make sure that the global MIDI channel
(Global P1: MIDI “MIDI Channel”) is set to 01.
• Arpeggiator A is assigned to T7 and T8, and
arpeggiator B is assigned to T5. When you play the
keyboard, the T7 program J068: HipHop Kit will be
sounded by the arpeggio pattern U444(User): Dr-In
The Pocket. The T5 program M034: Chord Trigger
will be sounded by the arpeggio pattern U123(A/B):
Syn-Echo.
• The B “Bottom Key” and “Top Key” (Combination P7:
Edit-Arp., Scan Zone page) are set so that arpeggiators
B will operate only for the G3 note and above.
• Arpeggiator B is assigned to T8 as well, but this
setting is so that the T7 program J068: HipHop Kit
will sound only when the arpeggiator is on. Refer to
the preceding section “Combination D062: Old Vox
Organ.”
Linking the arpeggiator to the combination
If you want the arpeggiator settings of a combination to
become active when that combination is selected, check
Combination for “Auto Arpeggiator” (Global P0: Basic
Setup, Basic page).
97
Program
Combination
Sequencer
Sampling
Song Play
Global
Effect
Media, etc
Preset
Other