show voice port - Tecnológico de Costa Rica

Using the Configuration STP Menu
(Root Bridge Only)
Using the Spanning-Tree Protocol 8 - 9
The STP Protocol for a root bridge is configured using the Configuration
STP Menu. This menu will only appear if the Root Mode is “On” as
described in Chapter 4 “Configuring the Radio Network”. To access
this menu, select Configuration from the Main Menu, then select STP
from the Configuration Menu.
Configuration Stp Menu
Option Value Description
1 - Active [ off ] - Protocol enabled
2 - Bridge [ menu ] - Bridge parameters
3 - Port [ menu ] - Port parameters
4 - Display - Protocol status
5 - State [ "Forward" ] - Local ethernet port state
Enabling STP Protocol (Active)
The active option acts as an On/Off switch for the STP protocol. The
default setting is “Off”, which means all root and repeater LAN ports
are placed in the forwarding state. If the option is turned “On”, the root
and repeater LAN ports are placed in the listening state.
If you are running a small infrastructure, and there will never be any
loops, leave the STP protocol “Off”. If you are unsure, change the setting
to “On” as the overhead involved for bridges is small.
Setting Bridge Parameters (Bridge)
The bridge option allows you to set the overall parameters and timeout
values for a root bridge. When the bridge option is selected, the Configure
STP Bridge Menu appears.
Configuration Stp Bridge Menu
Option Value Description
1 - Priority [ 8000 ] - Bridge priority
2 - Hello_time [ 2 ] - Hello message interval
3 - Forward_delay [ 15 ] - Forwarding delay
4 - Msg_age_timeout [ 20 ] - Receive hello message timeout