show voice port - Tecnológico de Costa Rica

Configuring the Radio Network 4 - 11
Using the Configuration Radio LinkTests Menu
The options in this menu can be used to determine system performance
on individual nodes as well as individual node radio performance.
Configuration Radio Linktests Menu
Option Value Description
1 - Strength - Run a signal strength test
2 - Carrier - Carrier busy statistics
3 - Multicast - Run a multicast echo test
4 - Unicast - Run a unicast echo test
5 - Remote - Run a remote echo test
6 - Destination [ any ] - Target address
7 - Size [ 512 ] - Packet size
8 - Count [ 100 ] - Number of packets to send
9 - Rate [ auto ] - Data rate
01 - Errors - Radio error statistics
02 - Autotest [ once ] - Auto echo test
03 - Continuous [ 0 ] - Repeat echo test once started
Enter an option number or name, “=” main menu, previous menu
>_
Running a Signal Strength Test (Strength)
The strength option sends a packet once per second to our parent access
point and each node in the association table. This packet is echoed back
to the Aironet 340 Series Bridge which records and displays the RF signal
strength associated with that particular node.
It can be used to quickly check the link to each radio partner or could be
monitored while aligning directional antennas between two nodes. As
the antennas are moved, the signal strength could be monitored until the
maximum value is achieved.
SIGNAL LEVELS
BRxxxx 00409611d1e5 Strength In *******************************
Out **********************************
(^C to exit) |--------------------------------|
Running a Carrier Busy Test
The Carrier option can be used to determine the amount of activity on
each of the available frequencies. Its main use is to pick an unused frequency
or to check for the presence of a jammer.