show voice port - Tecnológico de Costa Rica

timing wink-wait
To specify the maximum wink-wait duration for a specified voice port, use the timing wink-wait
voice-port configuration command. Use the no form of this command to reset the default value.
timing wink-wait milliseconds
no timing wink-wait milliseconds
Syntax Description
milliseconds Maximum wink-wait duration, in milliseconds, for a wink start signal.
Valid entries are numbers from 100 to 5000. Supported on E&M ports
only
Default
200 milliseconds
Command Mode
Voice-port configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3(1)T.
The call signal direction for the timing wink-wait command is out.
Examples
The following example configures the wink-wait duration on a Cisco 3600 series voice port to
300 milliseconds:
voice-port 1/0/0
timing wink-wait 300
Related Commands
You can use the master indexes or search online to find documentation of related commands.
timeouts initial
timeouts interdigit
timing clear-wait
timing delay-duration
timing delay-start
timing dial-pulse min-delay
timing digit
timing interdigit
timing pulse
timing pulse-interdigit
timing wink-duration
timing wink-wait
Voice Over IP for the Cisco 3600 Series Commands 4-81