show voice port - Tecnológico de Costa Rica

timing wink-duration
timing wink-duration
4-80
To specify the maximum wink signal duration for a specified voice port, use the timing
wink-duration voice-port configuration command. Use the no form of this command to restore the
default value.
timing wink-duration milliseconds
no timing wink-duration milliseconds
Syntax Description
milliseconds Maximum wink signal duration, in milliseconds, for a wink-start signal.
Valid entries are numbers from 100 to 400. Supported on E&M ports
only.
Default
200 milliseconds
Command Mode
Voice-port configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3(1)T.
The call signal direction for the timing wink-duration command is out.
Examples
The following example configures the wink signal duration on a Cisco 3600 series voice port to
300 milliseconds:
voice-port 1/0/0
timing wink-duration 300
Related Commands
You can use the master indexes or search online to find documentation of related commands.
timeouts initial
timeouts interdigit
timing clear-wait
timing delay-duration
timing delay-start
timing dial-pulse min-delay
timing digit
timing interdigit
timing pulse
timing pulse-interdigit
timing wink-wait
Voice over IP for the Cisco 3600 Series Software Configuration Guide