show voice port - Tecnológico de Costa Rica

show call active voice
4-46
Table 4-3 Show Call Active Voice Field Descriptions (continued)
Field Description
GapFillWith Redundancy Duration of voice signal played out with signal synthesized from redundancy
parameters available because voice data was lost or not received on time from voice
gateway for this call.
HiWaterPlayoutDelay High water mark Voice Playout FIFO Delay during this call.
Index Dial-peer identification number.
InfoActivity Active information transfer activity state for this call.
InfoType Information type for this call.
InSignalLevel Active input signal level from the telephony interface used by this call.
LogicalIfIndex Index number of the logical interface for this call.
LoWaterPlayoutDelay Low water mark Voice Playout FIFO Delay during the call.
NoiseLevel Active noise level for the call.
OnTimeRvPlayout Duration of voice playout from data received on time for this call. You can derive the
Total Voice Playout Duration for Active Voice by adding the OnTimeRvPlayout
value to the GapFill values.
OutSignalLevel Active output signal level to telephony interface used by this call.
PeerAddress Destination pattern associated with this peer.
PeerId ID value of the peer table entry to which this call was made.
PeerIfIndex Voice-port index number for this peer.
PeerSubaddress Subaddress to which this call is connected.
ReceiveBytes Number of bytes received by the peer during this call.
ReceiveDelay Average Playout FIFO Delay plus the decoder delay during the voice call.
ReceivePackets Number of packets received by this peer during this call.
RemoteIPAddress Remote system IP address for the VoIP call.
RemoteUDPPort Remote system UDP listener port to which voice packets are transmitted.
RoundTripDelay Voice packet round trip delay between the local and remote system on the IP
backbone during the call.
SelectedQoS Selected RSVP quality of service (QoS) for the call.
SessionProtocol Session protocol used for an Internet call between the local and remote router via the
IP backbone.
SessionTarget Session target of the peer used for the call.
SetupTime Value of the System UpTime when the call associated with this entry was started.
TransmitBytes Number of bytes transmitted from this peer during the call.
TransmitPackets Number of packets transmitted from this peer during the call.
TxDuration Duration of transmit path open from this peer to the voice gateway for the call.
VADEnable Whether or not voice activation detection (VAD) was enabled for this call.
VoiceTxDuration Duration of voice transmission from this peer to voice gateway for this call. You can
derive the Voice Utilization Rate by dividing the VoiceTxDuration value by the
TxDuration value.
Voice over IP for the Cisco 3600 Series Software Configuration Guide