show voice port - Tecnológico de Costa Rica

session target
session target
4-42
To specify a network-specific address for a specified dial peer, use the session target dial-peer
configuration command. Use the no form of this command to disable this feature.
session target {ipv4:destination-address | dns:[$s$. | $d$. | $u$.] host-name | loopback:rtp |
loopback:compressed | loopback:uncompressed}
no session target
Syntax Description
ipv4:destination-address IP address of the dial peer.
dns:host-name Indicates that the domain name server will be used to resolve the name of
the IP address. Valid entries for this parameter are characters
representing the name of the host device.
(Optional) You can use 1 of the following 3 wildcards with this keyword
when defining the session target for VoIP peers:
• $s$.—Indicates that the source destination pattern will be used as part
of the domain name.
• $d$.—Indicates that the destination number will be used as part of the
domain name.
• $u$.—Indicates that the unmatched portion of the destination pattern
(such as a defined extension number) will be used as part of the
domain name.
loopback:rtp Indicates that all voice data will be looped-back to the originating source.
This is applicable for VoIP peers.
loopback:compressed Indicates that all voice data will be looped-back in compressed mode to
the originating source. This is applicable for POTS peers.
loopback:uncompressed Indicates that all voice data will be looped-back in uncompressed mode
to the originating source. This is applicable for POTS peers.
Default
The default for this command is enabled with no IP address or domain name defined.
Command Mode
Dial-peer configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3(1)T.
Use the session target command to specify a network-specific address or domain name for a dial
peer. Whether you select a network-specific address or a domain name depends on the session
protocol you select.
Voice over IP for the Cisco 3600 Series Software Configuration Guide