show voice port - Tecnológico de Costa Rica

ing number
ring number
To specify the number of rings for a specified FXO voice port, use the ring number voice-port
configuration command. Use the no form of this command to reset the default value for this
command.
ring number number
no ring number number
4-40
Syntax Description
number Specifies the number of rings detected before answering the call. Valid
entries are numbers from 1 to 10.
Default
The default value is 1 ring.
Command Mode
Voice-port configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3(1)T.
Use the ring number command to set the maximum number of rings to be detected before
answering a call over an FXO voice port. Use the no form of this command to reset the default value,
which is 1 ring.
Normally, this command should be set to the default so that incoming calls are answered quickly. If
you have other equipment available on the line to answer incoming calls, you might want to set the
value higher to give the equipment sufficient time to respond. In that case, the FXO interface would
answer if the equipment online did not answer the incoming call in the configured number of rings.
This command is not applicable to FXS or E&M interfaces because they do not receive ringing to
receive a call.
Example
The following example sets 5 rings as the maximum number of rings to be detected before closing
a connection over this voice port:
voice port 1/0/0
ring number 5
Related Commands
You can use the master index or search online to find documentation of related commands.
ring frequency
Voice over IP for the Cisco 3600 Series Software Configuration Guide