show voice port - Tecnológico de Costa Rica

port
port
4-36
To associate a dial peer with a specific voice-port, use the port dial-peer configuration command.
Use the no form of this command to cancel this association.
port slot-number/subunit-number/port
no port
Syntax Description
slot-number/ Specifies the slot number in the Cisco router where the voice interface
card is installed. Valid entries are from 0 to 3, depending on the slot
where it has been installed.
subunit-number/ Specifies the subunit on the voice interface card where the voice port is
located. Valid entries are 0 or 1.
port Specifies the voice port. Valid entries are 0 or 1.
Default
No port is configured.
Command Mode
Dial-peer configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3(1)T.
Use the port configuration command to associate the designated voice port with the selected dial
peer.
This command is used for calls incoming from a telephony interface to select an incoming dial peer
and for calls coming from the VoIP network to match a port with the selected outgoing dial peer.
This command is applicable only to POTS peers.
Example
The following example associates a dial peer with voice port 1, which is located on subunit 0, and
accessed through port 0:
dial-peer voice 10 pots
port 1/0/0
Voice over IP for the Cisco 3600 Series Software Configuration Guide